BI017744
OPERATING INSTRUCTIONS RH 340 Inspection and servicing Handling batteries Battery Posts, terminals and related accessories contain lead and lead compounds, chemicals known to cause cancer and reproductive harm. Wash hands after handling
After the work: Reconnect first the positive and then the negative terminal.
Handling of cold-starting fluid (ether) Batteries give off explosive gases. Never handle batteries close to naked flames and unshielded light sources, never smoke. Battery acid is toxic and corrosive. Avoid any contact with the skin, mouth, eyes and clothing. Avoid spilling battery acid or inhaling the vapours. Wear gloves, firm protective clothing and goggles when handling batteries. If the skin is splashed with acid, rinse thoroughly with running water and consult a doctor. If the eyes are splashed with acid, rinse thoroughly with running water and consult a doctor immediately. Never set tools down on the battery. They may induce a short circuit, causing irreparable damage to the battery and injuring persons. Never wear metal necklaces, bracelets or watchstraps when working on the battery. The metal parts may induce a short-circuit resulting in burns. Dispose of used batteries separately from other waste in the interests of environmental protection.
Before working on the electrical system Before performing work on the electrical system where tools, spare parts, etc. can come into contact with electrical conductors or contacts, the battery must be disconnected. Disconnect first the negative and then the positive terminal.
BA RH340(3 720 350.01)-EN
The engine compartment can be equipped with pressure vessels containing cold-starting fluid (ether). Ether is toxic and highly flammable; the vessels are under pressure. These pressure vessels can explode if exposed to high temperatures (above 49°C / 120°F) or in the event of damage. Protect the pressure vessels against damage before beginning to work in or close to the engine compartment. Read and observe the instructions on the pressure vessels. For further details please refer to the instructions and safety data-sheets of the manufacturer / supplier of pressure vessels with cold starting fluid (ether). Provide for sufficient ventilation. Do not eat, drink or smoke when replacing an empty vessel. Do not inhale the vapours of escaping coldstarting fluid. In contact with the skin, ether can cause frostbites and irritations. Avoid skin contact. Wear suitable protective gloves and goggles. Even apparently empty pressure vessels can still contain rests of ether and therefore explode if they are damaged or heated up above 49°C. They must therefore be handled in the same way as full pressure vessels.
Do not keep them on the machine.
Do not damage or open the vessels.
Do not expose the vessels to great heat or direct sunlight.
Do not dispose of in fire.
Keep the vessels in a place inaccessible to unauthorized persons.
Dispose of the vessels properly.
3-7
