Fuel Injection Control Linkage

FLYWHEEL (1N3770 & 7N7732)

Make reference to FLYWHEEL RUNOUT for the correct method of flywheel inspection.

(1) Put 2P2506 Thread Lubricant on all the bolt threads that hold the flywheel to the crankshaft and tighten to a torque of ....................................1150 + 60 N-m (840 + 44 lb. ft.) NOTE: When flywheel is installed, put dash mark on flywheel (near pilot bore) in alignment with dash mark on crankshaft

NOTE: FOR TORQUE VALUES NOT GIVEN, SEE THE FIRST PAGE OF SPECIFICATIONS FOR GENERAL TIGHTENING TORQUES