T ravel reduction gears

Never put your hand in the quick coupler attempt adjust repair the quick coupler with the engine running.

Parking the machine

When parking the machine, proceed follows:

Position the machine flat, level ground, away from soft ground, excavations poorly shored cavities.

Place the upperstructure and the attachment in line with the undercarriage, retract the attachment and dig the bucket into the ground.

Stop the engine and remove the starter switch key .

Y must place the gate lock lever in the central position (safety bar in inward position) before leaving the operator's compartment.

Lock the cab door .

Make sure that the hoods and doors are properly latched.

Check that part the machine is encroaching the highway . this cannot avoided, install the necessary regulation signalling equipment.

Using the hydraulic breaker (optional)

Before using the hydraulic breaker , refer the operator's manual provided with the breaker .

Service and adjustment

Carefully read the information and instructions safety in this manual and understand them completely before servicing this machine.

When servicing the machine, wear appropriate work clothes. not wear baggy clothes.

Before removing any hydraulic line, completely bleed f the pressure within the hydraulic system. pressurized hydraulic oil leaks out, it may cause serious injury .

Attach the "Operation Prohibited" label the right side console before starting servicing the machine.

When using any tool that may send metal powder flying, wear protective eyewear . When installing a pin, use a copper other soft metal hammer .

Service defects and adjustment defects may lead a serious accident. you are unclear about the service procedures adjustment procedures, consult your CASE CONSTRUCTION dealer .

attachment is raised the machine moves while unmanned, this can cause a serious accident. the following work before servicing this machine. Stop the machine flat, level ground. Lower the attachment the ground. Stop the engine, then remove the key from the starter switch. Lock the tracks that the machine cannot move.

Unauthorized alterations this machine may lead a serious accident. not make any alterations whatsoever this machine without first consulting your CASE CONSTRUCTION dealer . Changes made this machine must comply with all current laws and regulations concerning safety and the technical specifications this machine.

For designated components, type approval is required.