Lower rollers

When replacing a designated component, always check that the new component complies with all laws and regulations. For the sake safety , use genuine CASE CONSTRUCTION parts.

10. pressure oil soaks deep into your skin, this can cause serious injury .

Always comply with necessary safety measures (protective clothes and protective gear for the face and hands) avoid risk.

Before using these products, read over the usage method in the operator's manuals for these products. hydraulic oil soaks deep into your skin, contact a doctor immediately .

1 Coolant solution is toxic.

Keep it away from your skin, eyes, and clothes.

First aid: it gets your skin clothes: Rinse it away with plenty water . T ake f any clothes with hydraulic oil them.

Ingested: not force vomiting.

Rinse out your mouth thoroughly with plenty water .

Seek immediate medical attention. it gets in your eyes: W ash it out with plenty water , then seek immediate medical attention. 12. A shoe tension cylinder has high pressure inside.

Adjust the shoe tension carefully according the procedures in this manual.

13. Always receive permission from the manufacturer before welding the undercarriage upper structure and always follow the manufacturer's instructions. When performing work, disconnect the battery and alternator B+ and terminals, then connect the ground cable for the welding equipment the component being welded.

Adjust the shoe tension carefully according the procedures in this manual.When welding the upper structure, never connect the welding equipment the undercarriage (or vise versa).

Never connect the welding equipment ground wire a component the hydraulic system.

14. When using compressed air , wear protective gear for the face.

15. Clean the machine periodically . grease, dirt, dust build up, they can cause damage the machine and injuries people.

16. As a part the machine service plan, periodically inspect the fastening state the main components the counterweight, turntable bearing, and operator's compartment. there is any problem, consult your CASE CONSTRUCTION dealer .

17. the accumulator is not functioning normally , consult your CASE CONSTRUCTION dealer .

Never perform service the accumulator .

Doing could cause a serious accident.

18. The accumulator has nitrogen gas high pressure sealed inside. not welding work use open flame around the accumulator .

19. While the engine is running and immediately after it stops, high - pressure fuel remains in the fuel supply pipe. Stop the engine, then wait for 2 min for the pressure in the fuel supply pipe drop before starting service.

20. While the engine is running and immediately after it stops, the computer injector is charged with high voltage. not touch the computer injector . it is necessary touch the computer injector in order service, consult your CASE CONSTRUCTION dealer .

Preventing fires explosions

Engine fuel can cause explosion a fire. • Never refuel when the engine is running. • Never smoke while refuelling. • T ake all necessary safety measures when welding, grinding working near a naked flame.

Always use a non - inflammable solvent for cleaning parts.

A spark a naked light can cause the hydrogen in a battery explode.