Batteries

you are obliged use the quick coupler with buckets not manufactured CASE CONSTRUCTION , make sure the diameter the pins and the width between the bucket lugs meet the dimensions needed fit the quick coupler (pins, washers, bushings, etc.). Consult your CASE CONSTRUCTION Dealer .

Operating the machine

When working a public highway , use standard traf fic signs and take into consideration the working range the upperstructure and its attachments. Local national regulations stipulate the number , type and location reflector strips. A void running the engine in a confined space. there is alternative, proper ventilation must provided all times.

not allow anyone else the machine. The passenger could fall cause accident.

Never operate the working travel controls unless you are properly seated in the operator's seat with the seat belt correctly fastened.

Before starting the engine, check the direction travel (in forward drive, the reduction gears should the rear the machine).

not work near overhead high - voltage electric lines without checking beforehand that all necessary measures have been taken respect the minimum distances: Less than 57000 V: 4 m ( 13.12 ) More than 57000 V: 5 m ( 16.40 ).

Study the position any existing pipelines conduits before starting work. Electrical cables, gas and water pipes and other underground installations can cause serious injury .

Always make allowance for working conditions (sloping rough ground), the site and weather conditions when driving the machine.

not allow anyone stand in the machine working area. Accidental operation the upperstructure swing control attachment control could cause accident. Stop all operations until everyone has moved away .

10. Operate all controls gradually ensure smooth machine operation.

1 Whenever load handling operations are carried out, it is imperative adhere strictly the instructions given in this manual and local legislation.

12. is forbidden use the machine carry out tasks other than those for which it is intended.

Never use the equipment for sweeping the ground level out rubble push objects (transversal stress the attachment).

13. Stop the engine and remove the starter switch key when the machine is not in use, even for short periods time.

14. The working area the end attachment that is mounted may interfere with the machine.

Interference may caused due the type end attachment installation parts such a cab guard.

Always maintain a safe margin distance. (Be careful tool swing accidental operations.)

15. To access exit the operator's compartment, the lefthand control arm must in the raised position.

Never forget this basic requirement.

16. Never leave the operator's compartment while the engine is running.

17. To get in out the cab, it is imperative that the upperstructure frame is in line with the undercarriage.

18. Dust, smoke mist can reduce visibility and cause accident.

Reduce speed come a complete halt until visibility has improved.

19. Never jump down from the machine.