MACHINE STORAGE
STORAGE REMOVAL 1. Fill the fuel tank. 2. Tighten the cooling system drain valves.
10. Prime the turbocharger oil lines w i t h o i l u s i n g t h e fo l l o w i n g procedure: A. Disconnect the electrical connector to the injection pump solenoid. This will prevent the engine from starting.
3. Put coolant into the engine cooling system. 4. Check the engine oil level.
B. Make sure all persons are clear of the machine. Turn the key switch to START and actuate the star ter for about 10 to 15 seconds.
5. Check the condition of the engine fan belt and replace it if required. 6. Check the hydraulic fluid level.
TRIM THIS EDGE
7. Use a petroleum base solvent and remove the Case Rust and Corrosion Preventive from the hydraulic cylinder rods and spools, etc. 8. Install a fully charged battery. 9. Remove air from the engine fuel lines.
C. Reconnect the wire to injection pump solenoid.
the
IMPORTANT: Before starting the engine, make sure there are no leaks, missing or broken parts. 11. Start the engine and run at idle speed for 2 minutes. Check for leaks around the filters and drain plugs. 12. Stop the engine and check the fluid levels of the engine cooling system and drive chain compar tments. See the Engine Cooling System and Drive Chain Compar tment sections for the correct procedure on checking the fluid levels.
168
TRIM THIS EDGE LEFT PAGE Bur 87592047na
