1650K
75
Every 250 hours work 12. ENGINE SUMP - Change oil (The oil change is performed at the same time of the replacement of the filter) Note – Comply strictly with the oil change interval at 250 hours or 3 months. The oil change and the replacement of the filter have the purpose of eliminating contaminants suspended in the oil.
3. To facilitate the draining, open the left front panel of the engine compartment indicated and loosen the oil filler neck cap B.
B A
Note – If the fuel used has a sulphur content higher than 1 %, the engine oil change must be done every 150 hours. Note – Drain the oil when it is hot and the contaminants are in suspension, thus proceed as follows:
D150-2M081
A MAX MIN.
D150-2M097
1. Operate the engine until the coolant temperature reaches 60 °C (140 °F), then shut-off the engine. 2. Remove drain plug T located on the bottom of the machine using a 10 mm (0.39 in) Allen wrench.
D150-2M082
A. Engine oil dipstick B. Engine oil filler neck
For the draining, use a container with a capacity of at least 20 lit (5 1/4 US Gal).
WARNING Use approved disposal sites or used oil collection centers. In case of doubts about the procedures for the management and disposal of used lube oils, contact the appropriate local authorities responsible for environmental protection.
WARNING
T
1850-2M0119
T. Engine oil draining plug
Avoid prolonged and repeated contacts of the skin with used engine lube oil which could be dangerous to your health. Avoid prolonged and repeated contacts of the skin with used engine lube oil which could be dangerous to your health. - Avoid contact with skin or eyes. If contact occurs, immediately clean the area throughly. - Keep oil and fluids away from children.
Carefully read personal and machine SAFETY PRECAUTIONS (at the beginning of this manual)
