NR STRIVE 11 & 13 GW DEMO BINDING

TO BE MOUNTED BY A SALOMON AUTHORIZED DEALER ONLY.

STRIVE 11 GW DEMO

STRIVE 13 GW DEMO

BINDINGS INTENDED TO BE USED ONLY WITH ALPINE BOOTS COMPLIANT WITH ISO 5355 STANDARD AND SKI BOOTS EQUIPPED WITH « GRIPWALK » LABELLED KIT OF WALKING SOLES

ISO 5355 WTR ISO 9523

ISO 23223

WARNING

THESE ALPINE BINDINGS ARE INTENDED TO BE USED ONLY WITH THE FOLLOWING SKI BOOTS: > Alpine ski boots compliant with ISO 5355 standard. > Ski boots equipped with « GripWalk » labelled kit of walking soles. Any use with other ski boots could cause the ski-binding-boot system to be faulty and affect release characteristics, which would increase the risk of serious injury while skiing. Therefore, skiers are warned not to use this product with any ski boots other than those meeting the standards indicated above. Skiers are advised to consult the dealer where this product was purchased, or an equipment specialist at any SALOMON authorized ski dealer of this product, for further information regarding which ski boots meet the standards listed above.

SOLE LENGTH ADJUSTMENT 253mm-376mm

ALPINE SKI BOOTS (ISO 5355) TYPE A (Adult) TYPE C (Children)

GRIPWALK BOOTS (ISO 23223) TYPE A (Adult) TYPE C (Children)

1. For mounting NR STRIVE 11 or 13 GW DEMO on skis, holes must be drilled with

Salomon mounting jig (ref L3086300001) to ensure a proper alignment of the binding. Mount front and rear plates on ski by tightening the screws with a 4 N.m torque

> > > NR STRIVE 11 & 13 GW DEMO BINDING

2. Insert the toe piece from the front and the heel piece from the back on their respective plates. Adjust it properly according to the boot sole length.

4. Select and adjust the setting release values for toe and heel pieces.

3. Step in the boot. Check and adjust the forward pressure.