LEISURE TRAK PLATE WITH M12 GW BINDING

TO BE MOUNTED BY A SALOMON AUTHORIZED DEALER ONLY.

BINDINGS INTENDED TO BE USED ONLY WITH ALPINE BOOTS COMPLIANT WITH ISO 5355 STANDARD AND SKI BOOTS EQUIPPED WITH « GRIPWALK » LABELLED KIT OF WALKING SOLES

ISO 5355 WTR ISO 9523

ISO 23223

WARNING

THESE ALPINE BINDINGS ARE INTENDED TO BE USED ONLY WITH THE FOLLOWING SKI BOOTS: > Alpine ski boots compliant with ISO 5355 standard. > Ski boots equipped with « GripWalk » labelled kit of walking soles. Any use with other ski boots could cause the ski-binding-boot system to be faulty and affect release characteristics, which would increase the risk of serious injury while skiing. Therefore, skiers are warned not to use this product with any ski boots other than those meeting the standards indicated above. Skiers are advised to consult the dealer where this product was purchased, or an equipment specialist at any SALOMON authorized ski dealer of this product, for further information regarding which ski boots meet the standards listed above.

SOLE LENGTH ADJUSTMENT Size M: 253mm – 320mm / Size L: 257mm – 380mm

ALPINE SKI BOOTS (ISO 5355) TYPE A (Adult) TYPE C (Children)

GRIPWALK BOOTS (ISO 23223) TYPE A (Adult) TYPE C (Children)

1. For mounting M12 GW bindings on skis, holes have to be drilled with the Salomon mounting jig (ref 30863001) to ensure a proper alignment of the binding. 1

> > > LEISURE TRAK PLATE WITH M12 GW BINDINGS

2

3

2. Mount the front and the rear plate on ski by tightening the screws at 4 N.m

3. Insert the toe and the heel piece and position on the track according to the boot sole length.

4. Step-in the boot and check the forward pressure. The forward pressure must be in the “OK” area.TECHNICAL MANUAL ALPINE 2022/23

4

5. Select and adjust the setting release values for toe and heel pieces. Concerning the DIN adjustment of the toe, do not go beyond the adjustment zone marked by the STOP. ▼

5