EASYTRAK PLATE WITH LITHIUM BINDING

TO BE MOUNTED BY A SALOMON AUTHORIZED DEALER ONLY.

ISO 5355

ISO 23223 WTR ISO 9523

WARNING

THESE ALPINE BINDINGS ARE INTENDED TO BE USED ONLY WITH THE FOLLOWING SKI BOOTS: > Alpine ski boots compliant with ISO 5355 standard. Any use with other ski boots could cause the ski-binding-boot system to be faulty and affect release characteristics, which would increase the risk of serious injury while skiing. Therefore, skiers are warned not to use this product with any ski boots other than those meeting the standards indicated above. Skiers are advised to consult the dealer where this product was purchased, or an equipment specialist at any SALOMON authorized ski dealer of this product, for further information regarding which ski boots meet the standards listed above.

SOLE LENGTH ADJUSTMENT Ski Woman (W): 253mm – 320mm / Size L: 257mm – 380mm

1. Use the Salomon mounting jig (ref:30863001) and drill the skis following the ski and binding manufacturer’s instructions.

Mount the front and rear plate on the ski by tightening the screws at 4 N.m. ▼

FRONT plate REAR plate

Below view

2. Insert the toe piece from the front and position on the track according to the boot sole length ▼

3. Insert the heel and break piece from the back and position on the track according to the boot sole length ▼

4. Boot sole length adjustment ▼

5. Step in the boot and check forward pressure ▼

6. Select and adjust the setting release values for toe and heel pieces ▼