Floor Pads Scotch-Brite™ Surface Preparation Pad Prepares wood, vinyl tile, sheet vinyl, marble, terrazzo and concrete floors for finish applications. These environmentally preferable pads require only neutral cleaner or water to effectively deep scrub and remove most floor finishes, leaving a clean surface ready for refinishing. The cleaning process is easy, there is no slippery residue from strippers, no stripper contact with skin and clothing, and no stripper clean up. Item #
Size
Pk/Qty
UOM
03189
8 in
25/Cs
CS
03190
12 in
10/Cs
CS
29595
13 in
10/Cs
CS
29596
14 in
10/Cs
CS
29591
15 in
10/Cs
CS
34815
16 in
10/Cs
CS
23276
17 in
10/Cs
CS
23370
18 in
10/Cs
CS
23369
19 in
10/Cs
CS
29592
20 in
10/Cs
CS
96891
12 x 18 in
10/Cs
CS
02590
14 x 20 in
10/Cs
CS
02498
14 x 28 in
10/Cs
CS
02499
14 x 32 in
10/Cs
CS
Floor & Carpet Care
Scrub and Recoat using 3M™ SPP (Surface Preparation Pads) Tools:
Procedure:
• • •
Step 1 – Generously apply diluted neutral cleaner to the pre-cleaned floor to be recoated.
• • • • • • • • • •
Mop bucket with clean water Clean mop Mop bucket with diluted neutral cleaner Wet/Dry Vac Easy Trap Duster material Easy Trap Holder and Handle (Optional) Floor Machine SPP Pads (Surface Preparation Pads) Backer Pad (Red or White) to put behind SPP pad on Machine)* SPP Doodle Bug Pads Doodlebug pad holder Wood Handle for Doodlebug pad holder Wax application system or mops, mop buckets and liners.
*Using a backer pad will allow the pad to work better on uneven floors and reduce “tiger stripping” caused by uneven pad pressure
Step 2 – Attach backer pad and SPP pad to the Floor Machine. Step 3 – Scrub floor north to south AND east to west to ensure a throughout and even removal of the top few coats of finish. Step 4 – Scrub all edges and hard to reach areas with SPP Doodlebug pad. Step 5 – Vacuum all water and finish residue with Wet/Dry Vac. Step 6 – Apply clean water to this area and vacuum area again to ensure a clean surface. Step 7 – Once completely dry check surface to make sure no white powder (dried wax) remains on the surface. (if white powder remains, repeat step 6) Step 8 – Use Easy Trap Duster to remove left over fine dust and particles. Step 9 – Apply 2-4 coats of additional Floor Finish.
www.NasscoInc.com
219