UPS A2, A3, A5 BATTERY CABINET USER’S MANUAL
Install the battery models after the DOS sheet is installed in the rack. CAUTION! Move and open the cartons carefully, leave the components packaged until ready to install.
2.4 Cabinet setup Locate the cabinet as the following items. 1- Place the cabinet in a protected area that has good ventilation, is flat and free of humidity, flammable gas, corrosion. 2- Make sure the air vents on the front and rear of the cabinet are not blocked. 3- No person is allowed to sit on it. Install the cabinet as the following process. 1- Mount the cabinet in a flat of (19-inch) rack, and tighten each other using four M6 machine screws ，then tighten the cabinet and orbit in real panel.(Fig.1)(Torsional moment: 33.0～61.0 kg.f.cm)
Front panel
DC
DC
tighten the two screws
Real panel 2-
Fig.1 Tightening cabinet
Install the battery models Remove the front panel (Fig.2). [4]
Copyright AST 2010
www.ast-global.com