LGC LIMITED EDITION
CUT SHEET
0.) INDEX
1.) EXTERIOR DIMENSIONS
2.) EXTERIOR COMPONENTS
3.) INTERIOR DIMENSIONS
4.) INTERIOR COMPONENTS
5.) FARM SITE/LEVELING
6.) WATER HOOKUP
7.) ELECTRICAL REQUIREMENTS
FREEZER DOOR HANDLE
MACH 8 ROOFTOP HVAC
30A MAIN BREAKER
220-240V SINGLE PHASE OR 208V THREE PHASE
ISO 1161 STEEL CORNER CASTINGS
INDUSTRIAL FORK POCKETS
FILL/DRAIN HOOKUP
2.) EXTERIOR COMPONENTS Insulated container with steel frame construction built with standard corner castings.
3.) INTERIOR DIMENSIONS
Approximately 8’ 9” x 6’ 2” x 6’ 8’’ interior space with 3’ x 6’ work zone where seeding/transplanting and harvesting take place.
4.) INTERIOR COMPONENTS
Interior component identification and location
5.) SITE PREP/LEVELING
The LGC should be placed on a level surface as all drainage angles are built into the design of the farm.
EMITTERS ABOVE EACH PLANT PANEL PROVIDE WATER TO THE GROW CHANNELS
MAIN IRRIGATION LINE DRIPS OUT OF THE CEILING IN THE FRONT RIGHT CORNER OF IRRIGATION LOOP
MAIN IRRIGATION LINE LIVES IN THE FRONT RIGHT WALL
SEEDLING TABLE HAS DRAINAGE BUILT INTO THE TROUGHS DIRECTING WATER TO THE BACK AND TOWARDS THE DRAIN ON THE RIGHT
6.) WATER HOOKUP
The LGC can be soft or hard plumbed. If you choose to hard plumb your LGC simply remove the included hose fittings and plumb directly to the bulk heads. We recommend heat tracing for your plumbing in cold weather climates
7.) ELECTRICAL REQUIREMENTS
The LGC requires a 30 amp feed with 220-240V Single Phase or 208V Three Phase.
BLACK (L1) RED (L2)
WHITE (N)
GREEN (GND)
FARM SYSTEMS
Time to take a closer look at some of the components in the LGC that make it grow!
HANGERS
CAROUSAL GROW STRUCTURE
THE SHELL
PLANT PANELS
SEEDLING STATION
LED GROW LIGHTS
CENTRAL COLUMN
EMBEDDED MAIN TANK
FREEZER DOOR HANDLE
THE SHELL
Designed and built from the ground up this insulated container is ideal for shipping, setting up and growing your leafy greens anywhere.
MACH 8 ROOFTOP HVAC
30A MAIN BREAKER 220-240V SINGLE PHASE OR 208V THREE PHASE
ISO 1161 STEEL CORNER CASTINGS
INDUSTRIAL FORK POCKETS
FILL/DRAIN HOOKUP
THE TANK
The tank is designed with the area below the plant panels slightly sloped towards the main sump. This allows all the water to drain back to the main sump where all pumps are located.
THE TANK
Accessibility to each section of the tank is important so we designed it with removable lightweight FRP panels (Fiberglass Reinforced Plastic) so cleaning is a breeze.
REMOVABLE FRP GRATING
REMOVABLE PANELS
BRUSH GROMMETS
COLLECTION BIN IS SLOPED TO DRAIN BACK TO SUMPELIMINATING THE NEED TO LEVEL THE FARM
115 GALLON SUMP TANK
7.5”
8’ 9”
THE TANK - PUMP LOCATIONS
The LGC includes four pumps. Main pump, Recirculation pump, Seed pump #1 and Seed pump #2. All of these are located in the sump under the FRP panels located by the Seedling Station.
THE HANGER - DIMENSIONS
The Hanger is double sided and holds four Plant Panels per side. Centered on the “back tabs” The organization of the front and back tabs allow the Panels to hang at the proper angle.
1.
2.
The hook on the back tab of the hanger sits through the slot in the back of the Plant Panel to secure it on the Carousel.
CAMERA #2
