Nebulizers Components CDR.7634
ZX.7169
ZX.7168
CDR.1456
CDR.7535
Pressure gauge ø40mm, case made of AISI 304 stainless steel, rear entry, G1/8" M-BSPT, 0-12bar
Nebulizer funnel with antioverflow ring, tank connection G1" 1/2F, cap connection G1" F, in AISI 304 stainless steel
Nebulizer funnel plug made of POM + O-Ring, funnel connection G1" M
Nebulizer funnel cap made of galvanised steel and O-ring, funnel connection G1" M
Ball valve, G1/4" M-F
MADE IN ITALY
With safety discharge hole
With safety discharge hole
CDR.7534
CDR.7537
CDR.7543
CDR.7541
Air pressure regulator, 0-8bar, G1/4" F-F with galvanised body
Air regulator, for foam Nebulizer, G1/4" M-M
Safety valve for compressed air, G1/8" M, calibration: 8bar, NBR seals
Discharge valve, G1/8" M, for foam Nebulizer
MADE IN ITALY
MADE IN ITALY
CDR.7527
CDR.7529
CDR.7619
CDR.7630
Wheel for 24L Nebulizer, black rubber, hub ø15mm
Stop disc, ø15mm, made of stainless steel, for wheel of Nebulizer CDR.7527
Wheel for 50L Nebulizer, black rubber, hub ø20mm
Stop disc, ø20mm, made of stainless steel, for wheel of Nebulizer CDR.7619
125mm
200mm
Blade pumps CDR.0788
CDR.0789
CDR.0787
Brass blade pump, 10bar, 100l/h
Blade pump made of stainless steel, 10bar, 100l/h. Complete with fitting clamp
Electric motor, for Blade pump, 240V-50Hz, 187W, IP54
• • • •
310
MADE IN ITALY
The pump must NEVER work without liquid We recommend using an inlet filter DO NOT operate at temperatures lower than 8°C At the end of the work it is necessary to flush the pump with water only
• • • •
The pump must NEVER work without liquid We recommend using an inlet filter DO NOT operate at temperatures lower than 8°C At the end of the work it is necessary to flush the pump with water only
Copyright© Idrobase Group. All rights reserved.