3 Lubricants for Gas Engines 3.1 Engine oils Dispose of used fluids and lubricants in accordance with local regulations.
Mixing different engine oils is strictly prohibited! Changing to another oil grade can be done together with an oil change. The remaining oil quantity in the engine oil system is not critical in this regard.
Engine oil requirements for gas engines Viscosity grade SAE 40 is stipulated for gas engines! Multigrade oils are not permitted! The selection of a suitable engine oil for gas engines depends primarily on the composition of the fuel used to power the engine. The gas engine must only be operated with approved lube oil. The engine oils to be used must be taken from the table (→ Page 127). Another significant factor is the quality of the gas regarding its purity. This requires that the operator regularly carries out gas checks. The gas engine oils to be used are characterized by the lowest possible ash content. This prevents increased ash deposits which can lead to reduced catalytic converter performance or combustion knocking.
Oil drain intervals for gas engines Series 4000 Engine oil drain intervals depend on the engine-oil quality, its conditioning, the operating conditions and the fuel used. For this reason, an oil sample must be taken every 250 operating hours and the oil analysis must be compared to the limit values (→ Table 7). The oil samples must always be taken under the same site conditions (engine at operation temperature) and at the designated point (extraction nozzle on oil filter housing). When the limit values (→ Table 7) are reached or exceeded, an immediate oil change is necessary. When using increased oil volumes, the limit values for wear elements must be reduced inversely proportionally to the volume increase (see following example). Double oil volume = halved limit value of the wear element (e.g. iron (Fe) --> 15 mg/kg). The maximum permissible reduction of limit value for the wear elements is 50% of the limit value (→ Table 7). The results of the oil analyses must be archived and the last respective oil sample must be stored for any necessary follow-up examinations. If the limit values are not achieved, an oil change must be carried out after one year at the latest.
During operation with gases containing silicium, take particular note of the increased silicium content in the oil. For this purpose, the silicium operational value SiB must be calculated with the help of the formula below. The limit value for the silicium operational value is 0.01. If this value is exceeded, the engine is being operated outside the fuel specifications and the warranty becomes void. More details can be obtained in the chapter "Fluids and lubricants for gas engines" (→ Page 86). The comprehensive observance of SiB must be verified by the operating company with the help of oil analyses Si(n). SiB = Delta Si (ppm) oil analysis (Si(n) – Si(n – 1)) x
18 | Lubricants for Gas Engines | A001061/37E 2016-12
[Oil filling quantity + refilling quantity (liter)] Generated electric work (kWh)
TIM-ID: 0000034889 - 003
Special gas
