Instrument Cluster

Engine Coolant Temperature Warning Indicator

This is a Red LED and is located on top of tachometer. It will glow continuously when temperature of coolant rises above 228.20 F. The pointer of Temperature gauge will lie in the RED band under such condition. Also to warn the operator, A beeper will also give an audio warning. (60 beeps / Min)

Air Filter Clogging Indicator

This is an Amber LED and glows when Air filter is clogged. This gives an indication to the customer that the air filter needs to be cleaned for proper functioning.

Check Engine Indicator

This indicator will glow when the starter switch is turned to "ON" position. This indicator will turn-off after engine is CRANKED. A malfunction other than Emission, such as Sensor failures would be indicated by a continuously "GLOWING" or "BLINKING" Indicator, even past CRANKING of the engine. In such an event, get the problem rectified by an authorized Mahindra Dealer.

High Beam Indicator

This is a Blue LED and glows when Head Lamps are operated in High Beam.

Clutch Over Ride Indicator

Optional feature: This is an Amber LED & Glows when clutch Pedal is pressed for more than 10 sec.

This symbol will be glowing if the feature is equipped.

F-R Shuttle Neutral Indicator

This is a Green LED and glows when the F-R shuttle shift lever is not in neutral position.

Fuel Gauge

The Fuel Gauge is displayed on the left side of rpm meter when viewed from the driver’s seat. It indicates quantity of fuel available in the fuel tank. The indication is divided into 9 stages. The Red zone indicates that the fuel level is less and the tractor should be refueled for uninterrupted run.

Continued operation of engine despite the high temperature warning indicator glowing may lead to engine seizure.

Low fuel indication & buzzer ON at 2nd Graduation & OFF at 3rd Graduation. Buzzer sound at the rate of 15 beeps per min.

4WD Indicator

This is a Green LED and glows when 4WD is engaged. This LED will glow only in 4WD tractor version.

Turn Indicator

These are Green LEDs. LH and RH turn indicators are provided to indicate the direction of turning. A blinking LH turn indicator implies that the LH Turn Signal indicator of tractor is ON whereas a blinking RH turn indicator implies that the RH Turn Signal indicator of tractor is ON.

No. of flashes of these LEDs: 60-120 counts/minute

If the count is more than 140 per minute, then it is an indication that one of the bulbs is not functioning.

Tachometer

This gives the number of Revolution per Minute of the engine. To arrive at the rpm value at any given point of time, multiply the pointer reading by 100.

Example: If the reading shows 15, the actual engine rpm value = 15 x 100 = 1500

Trip Hour Counter

This is a LCD hour counter located under the tachometer. It is operated by signal from ECU, when the engine is running. Trip hour counter displays the running hours for the particular trip. The run hour is calculated in real time, i.e. 60 minutes of tractor run is calculated as 1 hour only. After 999 hours is completed, the count restarts from 0. The blinking of the symbol indicates that the run time is counted on real time.

Tractor Run Hour Counter

This is a LCD hour counter located under the tachometer. It is operated by signal from ECU, when the engine is running. Hour counter displays the cumulative engine running hours. The run hour is calculated in real time, i.e. 60 minutes of tractor run is calculated as 1 hour only.

Trip Hour Reset Button

This is located on cluster bezel and is used to reset the trip hour meter as and when required. This can be done by continuously pressing the button for 5 seconds.

Water In Fuel Indicator

This is Amber LED and glows when water is accumulated in the fuel filter. The operator has to drain the water by opening the sensor in fuel filter.