INSTRUMENTS AND CONTROLS

Moving Regeneration

regeneration occurs while the vehicle being driven and can automatic (no operator input needed start regeneration) manual (operator input needed start The operator notified that a regeneration needed when the icons the DPF Smart switch illuminate (refer Figure listed

Note: The vehicle operator should try maintain vehicle speed during the regeneration process. the vehicle must stopped (at a traf fic light for example), allow the vehicle idle and not apply the park Applying the park brake will disrupt and end a regeneration that started while the vehicle was being driven.

Please refer the instructions below how use the DPF Smart switch during a regeneration that occurs while the vehicle being driven.

1 When the icons the DPF Smart switch light up, maintain vehicle speed possible.

2 During the icons the switch will shut

3

4 T o stop

Regeneration will take between and minutes regeneration, press the switch down the inhibit position. When the bottom the switch illuminated, regeneration stopped. The switch will remain locked this position and the light will stay illuminated. The driver has the option stopping a regeneration the vehicle area where elevated exhaust temperatures will pose a hazard (i.e., tunnel, under trees, area where there flammable material, etc.).

1 When the icons the DPF Smart switch light up, maintain vehicle speed and press and hold the top part the switch momentarily .

2 During regeneration, the icons the switch will shut

3

Regeneration will take between and minutes

4 T o stop regeneration, press the switch down the inhibit position. When the bottom the switch illuminated, regeneration The switch will remain locked this position and the light will stay The driver has the option stopping a regeneration the vehicle area where elevated exhaust temperatures will pose a hazard tunnel, under trees, area where there flammable https://www.truck-manuals.net/

Depending the s set up, may possible perform a parked regeneration necessary .