MAINTENANCE AND LUBRICA TION TTER Y

Caution

T o avoid damage sensitive electr onic equipment, disconnect ALL battery cables and harnesses electr onic contr units befor e welding. NOT disconnect batteries while engine running.

Jump-Starting Engine you encounter a situation which necessary jump - start use the following

W Arning

Batteries which e linked together must the same voltage (12 12, 24). T ake car e observe oper polarity when connecting batteries. Batteries oduce explosive gases. Keep sparks, flames, cigar ettes, etc., away batteries all times. otect your eyes wearing safety goggles. sur e vehicles e NOT touching each other .

Caution

T o avoid damaging any electr onic contr ollers when jump - starting a V - MAC vehicle, always turn the ignition switch OFF befor e connecting the

Note: Y our vehicle may equipped with a jump - start connector which located the left rear side the cab.

Connect the positive (+) cable positive (+) post discharged battery the positive post the remote jump - start connector (if equipped).

Connect the other end the same cable the positive (+) post the booster battery .

Connect the second negative ( the other post the booster battery https://www.truck-manuals.net/

Make the final connection the negative ( battery terminal the remote jump - start connector (if equipped) the stalled and stand

Start the vehicle with the booster batteries and then start the stalled vehicle. Shut down the vehicle with the booster batteries and remove the cables the reverse order connection.

W Arning

NOT connect the final negative ( connection the frame the stalled vehicle. This would cause all curr ent flow thr ough the master ound cir cuit eaker r esulting overload.