Control and operation

Press the Menu key again. The screens 5, 6, 7 and 8/... are successively displayed.

The screens 5/... to 8/... provide an overview of the status of the different electrical inputs and outputs.

A “” means "Input not active".

A “”means "Input active".

An “NC” beneath the terminal designation means that the corresponding input has been deactivated in the software.

The duration indicated in the last line of the screen 4/7, under M4/Time corresponds to the pause time for the windshield wiper in intermittent mode.

Menu "Info In/outputs" Status of electrical inputs and outputs

–Input D+ indicates if the motor is running.

–The input A9 attests that the measured servo control pressure for stick movements amounts to at least 7 bar (pressure transmitter B159).

–The input A18 attests that the measured servo control pressure for boom movements amounts to at least 7 bar (pressure transmitter B160).

–The input A20 attests that the measured servo control pressure for swing movements amounts to at least 7 bar (pressure transmitter B167).

–The input A21 attests that the measured servo control pressure for travel movements amounts to at least 7 bar (pressure transmitter B162).

–The input A23 attests that the measured servo control pressure for bucket tilt movements amounts to at least 7 bar (pressure transmitter B163).

To exit the menu: Press the Back key. The sub-menu will be aborted.

Menu "i-errors" - operating faults and electrical system errors