27 - Driveline
03 - Manual Gearbox 58 - Output Shaft
Remove and Install Special Tools Description Drive Coupling Spanner Spacer Kit Spacer Kit
Figure 568. B
Part No. 892/00812
Qty. 1
921/52600 921/53400
1 1
A C
D F
E G
Before removal 1. Remove the front and rear gear case. Refer to Manual Gearbox, Front Case- Remove and Install (PIL 27-03-90).
Remove 1. Unstake the retaining nut. Refer to Figure 568. 2. Support the output shaft from inside the rear case. Refer to Figure 568. H
3. Use a spanner to hold the output yoke and at the same time loosen the retaining nut. Refer to Figure 568. Special Tool: Drive Coupling Spanner (Qty.: 1)
A B C D E F G H J
4. It is necessary to get the help of an assistant as the retaining nut is very tight. Refer to Figure 568. 5. Hold the output shaft from below. Refer to Figure 568.
J
Retaining nut Stepped washer Output yoke Oil seal Outer bearing Spacer Rear gear case Bearing Output shaft
6. Remove the retaining nut and the stepped washer. Refer to Figure 568. 7. Remove the output yoke. Refer to Figure 568. 8. Remove and discard the oil seal.Refer to Figure 568. 9. Make sure that the seal housing is not damaged. Refer to Figure 568. 10. Remove the output shaft with the bearing from inside the rear gear case. Refer to Figure 568. 11. Remove the outer bearing and the spacer and keep it for assembly. Refer to Figure 568. 12. If necessary, remove the main shaft bearing outer cup from the centre of the output shaft transfer gear. Refer to Figure 569.
27 - 151
9813/8300-1
27 - 151