Replacing Saw Bar

Before performing any maintenance or service work, lower the attachment to the ground and shut off the engine. Turn off any master shut-offs and do not allow personnel in the cab.

When working on the saw chain always ensure the engine is shut off and wear safety gloves to prevent injuries. Remove the saw chain when making any adjustments or servicing the saw unit. Place the unit steady on the ground with the SuperCut unit facing up.(Where possible) Remove the saw chain. Loosen the Hex Nuts(5) , use a 36 mm wrench, until you are able to pull out the saw bar. Install the saw bar and tighten the Hex Nuts(5). Install the saw chain.

Fig. 21Replacing Saw Bar Pin Bar Holder Guide Pins Grooves Hex Nuts Tension Device Pin