Installing saw motor

Never hammer or pry on saw motor when assembling or disassembling, always use Puller P/N 0696167 ( ) which is designed especially for this purpose.Bearings in the saw unit and the saw motor can easily be damaged if care is not taken. Carefully clean both the saw motor and the saw unit bearing to keep dirt out of the swivel. Assemble the puller according to the following figure. Connect the puller bolt to the threaded hole in the saw motor shaft. Use tool P/N 0704040 to hold the puller bolt still, while turning the nut clock wise with a wrench size 24mm to pull the saw motor into the saw unit. Remove the puller. Replace the two fasteners (4) for the tension device (1). Install the fasteners (5) for the saw motor.

Install the fasteners for the washer (2). Install all hydraulic connections to the new saw motor. Install the drive sprocket and the chain catcher. Install the saw chain.

When working on the saw chain always ensure the engine is shut off and wear safety gloves to prevent injuries. Remove the saw chain when making any adjustments or servicing the saw unit.

Fig. 34Puller P/N 0696167 Puller Bolt Nut Girder

Fig. 35Installing Saw Motor Tension Device Washer Fasteners for washer, 16 pcs. Fasteners for tension device Fasteners for saw motor, 6 pcs.