Adjusting sensors ......................................33

To work satisfactorily, the sensors for the cut-control device and saw home detector, must be placed approx. 0.5 mm from the target area. To achieve that, do as described below. For better access to sensors, always remove the housing for the sensors when working on the sensors. Remove the Electric wire connector from the sensor. Gently screw the sensor(3) by hand through the plate(1) until it reaches the target area. Unscrew the sensor 1/2 turn. The sensor should now be approx. 0.5 mm from the target area.

If the connector pins are being used as aims, it should be easy to adjust the sensor within the ±5° degrees necessary to make the sensor work properly.

The sensor has to be unscrewed 1/2 turn ±5° as the function of the cut control device is depending on the proper adjustment of the sensor. Lock the sensor with the nut(2). Do not use glue when locking the sensor, as this will make it hard to readjust or remove the sensor.

Fig. 43Adjusting Sensors Plate Nut Sensor Electric Wire Connector

Fig. 44Unscrewing Sensor