Operation – Starting the engine 4.
Turn the ignition key to position “I”. ð The warning buzzer sounds.
B-ELE-0070
Fig. 41 5. The starter switch is designed with a re-start lock. The ignition key must first be turned back to position “0” before a new starting attempt can be made.
NOTICE! Components may get damaged! – Starting attempts should not exceed 30 seconds uninterrupted or max. 3 times for 10 seconds. Then allow the starter to cool down to ambient temperature. – If the engine has not started after these attempts, determine the cause.
B-ELE-0072
Fig. 42
Turn the ignition key through position “II” to position “III”. ð The starter cranks the engine. The warning buzzer must stop. 6.
If the warning buzzer does not stop after the engine has started: n Park the machine safely Ä Chapter 6.4 ‘Parking the machine in secured condition’ on page 59. n Check the engine oil level; top up if necessary Ä Chapter 5.3.1 ‘Checking the engine oil level’ on page 50. n If necessary, contact our Customer Service.
7.
Run the engine warm for approx. 1 to 2 minutes in idle speed. NOTICE! Danger of engine damage! – Warm up engine for a short while before starting work. Do not operate the engine immediately under full load.
56
DRP25D
