W asher 9 X X1.6 4

3 - GENERAL INFORMA TION ###_1_###

Basic instructions

READ THE FULL INSTRUCTION BEFORE ARTING THE INST ALLA TION!

• References “left” and “right” are determined from the rear , facing in the direction travel the machine during operation. • To access the dif ferent components, see the operator ’s manual the machine. • Callout references:

- Numeric callout references (example: (1) refers item (1) in the kit content list. - Letter callout references (example: (A) refers the component the unit, not item in the kit content list.

• Use A NTIFRET minimize fretting corrosion between two metal surfaces. Fretting corrosion is caused very slight oscillations vibrations. This may lead serious damage in bearings and other machine parts and can make dismounting almost impossible. • Always tighten the hardware unless instructed not tighten in the step involved. • Tighten the hardware the standard torque specifications unless otherwise instructed. • Make sure use the hardware specified in tapped holes. Install a metric bolt in a metric thread inch bolt in inch thread, otherwise you will damage the threads! • Install flat washers over all slotted holes unless truss - head carriage bolts are used. Install a lock washer all the bolts unless a jam nut a lock nut is specified. • Install special hardened washers where specified.