Side Mount Control Head

SIDE MOUNT CONTROL HEAD Port 229-3689 Starboard 229-3690

For single engine installations connect the Side Mount control head into the port connector on the CSP .

TYPICAL INSTALLATION

Starboard Throttle Installation Shown

The installation of the side mount controls must not place any static side load on the shaft .

Mounting Instruction:

1 . Determine the center line of the shaft location . 2 . Drill a 7/8" (0 .875") hole centered on the shaft location and parallel to the shaft center line . 3 . Insert the shaft in the side mount control . Tighten the primary set screw (long) against the shaft and then install the secondary set screw (short) to lock the primary set screw . 4 . Mount the side mount control in place and verify that all mounting points are tight . 5 . Visually inspect the 7/8" hole and verify the hole is centered and parallel to the shaft . 6 . Place the bearing over the shaft and slide it into the 7/8" hole . The bearing should fit snugly into the hole, but it should not place any side load on the shaft .