Battery Parameter Setting

Battery Parameter Setting

• When the truck is switched on, “99%” is displayed. The current battery capacity is then displayed. Provided “99%” is displayed, there is no valid reading and the truck is not yet operational.

Para meter

Display Setting range Mode

P01 BATTERY TYPE 0..3 Service Sets battery type (see table).

Meaning

P02 BATTERY (AH) 0..9 Service Sets battery capacity (see table).

P04 OFFSET FULL 0..9 Service This parameter sets the voltage which corresponds to 100% of battery capacity (see OFFSET FULL table).

P05 OFFSET EMTY 0..9 Service This parameter sets the voltage which corresponds to 20% of the residual capacity or 0% of the available battery capacity (see OFFSET EMTY table).

P12 CURRENT APROX. 0..9 Service This parameter is used to estimate the battery’s residual capacity if it is not possible to record the off-load voltage for a long period of time.

BATTERY TYPE parameters

Parameter

0 1 2 3

Battery capacity

400 AH 440 AH 500 AH 550 AH

BATTERY parameter

Parameter Battery capacity Parameter Battery capacity 0 400 AH 5 700 AH 1 440 AH 6 770 AH 2 500 AH 7 800 AH 3 550 AH 8 880 AH 4 600 AH 9 1000 AH

BATTERY and CURRENT APROX. Parameters

The current set in the “Current Aprox.” Parameter (Imean) and the uninterrupted operating time (T) can be used to calculate the capacity taken from the battery.

If the value calculated exceeds 10% of the available battery capacity (= battery parameter), the battery capacity displayed will be reduced accordingly.

Lift cutout for discharged battery:

If the residual capacity reaches 0%, the “lift” function is deactivated (lift cutout). Lifting is only enabled again once the battery is re-charged to at least 40%.

Exception: If the truck is powered up again the capacity calculated is less then 40%, lifting is possible for approx. 30 seconds (traveling on inclines). The capacity displayed remains at 0%.

OFFSET FULL parameter

See JUDIT.

OFFSET EMPTY parameter

See JUDIT.