OPERATING INSTRUCTIONS RH 120 E Operation WORKING OPERATION Running-in instructions for hydraulic cylinders
Safety instructions
Read the sections "Fundamental safety instructions" and "Operation, safety instructions" carefully and observe the instructions given in them. Inspect the site for underground gas, power and water lines before starting work. Any damage to such lines is a risk to life! Clean off any earth, mud, snow, ice, grease and oil adhering to your working footwear before operating the machine. There is otherwise a risk of slipping off the pedals and initiating inadvertent movements. Sound the horn to warn persons in the immediate vicinity before starting work. Stop work if anyone is in the hazard range of the machine. Make sure they have left the hazard range before resuming work.
Compression of an oil/air compound in a hydraulic cylinder may result in detonations which might damage pistons and sealing rings. Prior to initial commissioning and/or after repairs, run in the hydraulic cylinders as follows: Ü Switch on the electric motor. The pressure-limiting valve in the hydraulic system must not respond Ü In the first two working cycles, retract and extend the pistons of the hydraulic cylinders to max. ½ to ¾ (not to the limit stop). Never change direction suddenly. The waiting time between changes of direction must be at least 4 seconds. Ü In the next eight working cycles, retract and extend the pistons of the hydraulic cylinders to the limit stop. The waiting time between changes of direction must be at least 4 seconds. Ü When all hydraulic cylinders have been run in, the excavator can operate at a higher engine speed.
Never operate the machine unless it is standing on a reasonably horizontal, flat surface. The stability of the machine is otherwise at risk. Ensure that the attachment has adequate clearance below overhead power lines and structures. Trenches and working faces may give way. Keep well clear of them.
BA RH120E(3 664 090.00)-EN
2-59
