Safety Precautions

I

General GASOLINE ENGINE

Type ----------------------------------- 4 Cylinder, 4 Stroke Cycle, Valve-In-Head. Firing Order -;....-------------------------------"------ 1-3-4-2 Bore ----------------------------------------- 4-3/8 Inches .Stroke , -;-------------------------.------------------ 5 Inches Compression Ratio --------------------------------- 7.5 to 1 Ei!i!ton Displacement ------------------------ 301 Cubic Inches Cylinder Sleeves ------------------------ Replaceable Wet Type Maximum Rated Horsepower 1 - (Gross) ------------------:----- 82 H.P. @ 2000 R.P.M. 2 - (SAE Net) --------------------77 .3 H.P. @ 2000 R.P.M. Engine Speeds

High Idle - No Load------------------- 2170 to 2200 R.P.M.

Rated - Full Load --------------------------- 2000 R.P.M.

Low Idle -----------..;-------------------..; 725-775 R.P.M. *Valve Tappet Clearance (Intake) --------------- .015 Inch (Cold) (Exhaust) ---------------.025 Inch (Cold) Exhaust Valve Rotators ------------------------ Positive Type

1 - Manufacturer's rating of maximum engine horsepower at flywheel when equipped with oil and water pumps. Fuel set at maximum quantity for the application. Corrected to sea level -29.92" Hg. and 60° F. dry air.

2 - SAE net flywheel horsepower of engine as applied to this vehicle when equipped with operating accessories including oil and water pumps, alternator, air cleaner, fan and muffler.

Corrected to 500' altitude with .3811 Hg. vapor pressure (29.3811 Hg. observed barometer) and 85° F. air (per SAE

J816a).

Pistons and Rods

Rings Per Piston----------------------------------------"'"'.-- 3 Number of Compression Rings------------------------------- 2 Number of Oil ---------------------------------------- 1 Type Pin ---------------------------------- Full Floating Type Type Bearings ------------- Replaceable, Precision Steel Back, Copper Lead Alloy Liners.

Main Bearings

Number of Bearings ---------------------------------------- 5 6

Type Bearings ---------------Replaceable, Precision Steel Back, Copper Lead Alloy Inserts.

Engine Lubrication System

Oil Pressure ------------------ 40 t.o 50 PSI With Engine Warm and Operating at Full Governed RPM, Type System ----------------- Pressure and Spray Circulation Oil Punlp --------------------------------------- Gear Type Oil Filter ------------------------------Replaceable Cartridge

Ignition System

Spark Plugs ----------------------------------- Prestolite 18 8 Or Equivalent. Thread ---------------------------------------------- 18MM Gap ------------------------------------------------ .025 Inch Shank Length ------------------------------------- 1/2 Inch Rtmning Timing at Rated Engine RPM--------------- 28° BTDC Static Timing ------------------------------------- 5° ATDC Distributor Point Gap ----------------------------- .020 Inch Dwell Angle --------------------------------------------- 70"

Fuel System

Type System ---------------------------------- Gravity Flow Carburetor ------------------------------- 1-1/4" SAE Flange Fuel Filter Brass Screen,, Located. Under Fuel Tank. Fuel Tank Water Trap and Drain ----- Located in base of fuel tank Fuel Gauge----------------------- Electric, Located on Instrument Panel. Fuel Tank Capacity ------------------------25.5 U. s. Gallons

POWER TRAIN

Torque Converter ----------------------------- Ratio 3 to 1 Transmission ----------- Full Power Shift in Forward and Reverse 4 Speed Ranges in Forward 4 Speed Ranges in Reverse Axles and Planetary ----------------- Spiral Bevel with Planetary Reduction in Hub.