2 minute read
FUEL SYSTEM
Template Date: 1994_04_29Template Name: OM_1_col
TRIM THIS EDGE
COOLING SYSTEM Service specifications
Coolant reservoir level check..........................................................Every 10 hours or every day Coolant solution change................................................................Every two years or twice a year (autumn/spring) if antifreeze is used System capacity...............................26.4 litres (CX210, CX230); 27 litres (CX240)
WARNING: Boiling coolant solution can spray out if the radiator cap is removed while the system is still hot. To remove the cap, allow the system to cool down, turn the cap to the first notch and wait until there is no more pressure. Then remove the cap.
WARNING: Check and service the cooling system according to the instructions given in this manual.
!
Coolant solution
Put only ethylene-glycol coolant solution in the cooling system. Use good quality ethylene-glycol that has a high boiling point, with no additives to prevent leakage. Do not use non-approved anti-rust additives. Anti-rust additives and ethylene-glycol can mix and work against each other, thereby reducing anti-corrosion protection, forming deposits in the cooling system and causing damage to the cooling system and radiator. Consult your CASE Dealer for suitable coolant solution.
158
TRIM THIS EDGE LEFT PAGE
Level
The level of coolant solution should be checked when the engine is cold.
2 1
WARNING: Do not remove the radiator cap when the engine is hot. The system is still under pressure and you could be scalded.
CD00E106 On flat, level ground, before using the machine, (while the engine is still cold), the level in the coolant reservoir should be between the “FULL” (1) and “LOW” (2) marks. If not, see “Filling”.
Draining
CD00E103 2. Open the radiator drain valve. NOTE: Have a receptacle of a suitable capacity ready. TRIM THIS EDGE
1. Remove the radiator cap.
CD00E104 CD00E105 3. Open the drain plug located on the engine block. NOTE: Have a receptacle of a suitable capacity ready.
159
TRIM THIS EDGE RIGHT PAGE
Template Name: OM_1_colTemplate Date: 1994_04_29
Template Date: 1994_04_29Template Name: OM_1_col
TRIM THIS EDGE
Rinsing
1. Close the drain valve once the radiator is completely empty. Close the plug on the engine block. Fill the system with clean water. Install the radiator cap. 2. Start and run the engine at a speed slightly higher than low idle for ten minutes to bring the engine temperature to approximately 80°C. 3. Drain the system once more. 4. Repeat Steps 1 to 3 until the water drained is clear.
Filling
CD00E106 2. Fill the expansion reservoir to the “FULL” mark and install the cap. IMPORTANT: Use the correct coolant solution. 3. Run the engine at idle speed for about five minutes. Add coolant solution if the level in the expansion reservoir drops. IMPORTANT: Do not fill the expansion reservoir above the “FULL” mark.
CD00E104 1. Fill with coolant solution via the radiator until overflowing and install the radiator cap.
160
TRIM THIS EDGE LEFT PAGE
