OPERATING INSTRUCTIONS Daily Inspection Do the following each day before you start the engine.
5. Clean all debris from the machine, especially around the engine and radiator.
1. Check the operation of the seat bar and operator presence switch, see pages 197 and 198.
6. Clean or replace any safety or instructional decals that cannot be read.
2. Check the machine for leaks. Repair all leaks and clean the area with solvent, or pre ssure wash using soap and water.
7. Clean the hand rails, steps, and operators compartment. Remove all loose items from the machine. 8. See the maintenance charts in this manual. Complete the procedures in the section marked Every 10 Hours of Operation.
4. Check for damaged, loose, or missing parts. Replace, tighten, or a d ju st a s r e q u ire d b e fo r e y o u operate the machine.
NOTE: If this is a new machine, or a machine with a new or rebuilt engine, see “Run-In Period”, page 100.
Starting The Engine
WARNING: Before you start the engine, read and understand the operator’s manual and the safety decals for this machine. ALWAYS fasten the seat belt and pull seat bar down. Make sure all other persons in the area are away from the machine. SC004
WARNING: Before starting the engine, study the operator’s manual safety messages. Read all safety signs on machine. Clear the area of other persons. Learn and practice safe use of controls before operation. It is your responsibility to understand and follow the manufacturer’s instructions on machine operation, service, and to observe pertinent laws and regulations. Operator’s and service manuals can be obtained from your dealer. SB055
1. Adjust the seat and fasten the seat belt.
4. Push the throttle forward approximately 25 mm (one inch).
2. Pull the seat bar down.
NOTE: If the weather is cold, see “Operating in Cold Weather” for starting aids on page 108.
3. Alert any person in the area that you are going to start the engine.
99
TRIM THIS EDGE Bur 9-28727NA RIGHT PAGE (First)
TRIM THIS EDGE
3. Check the tires for damage.
