REPLACING A HOSE

STEP 4

Operate the connecting rod control so as to engage it in the hydraulic breaker, then stop the engine and remove the starter switch key.

STEP 5

Install the connecting rod/hydraulic breaker linkage pin and then install the retaining hardware (this can vary depending on the mounting arrangement) on the linkage pins.

STEP 6

Open the shut-off valves (for opening or closing the circuit) on the lines, if fitted.

STEP 7

Remove the lifting ring and plug the lifting ring hole.

STEP 8

Grease the linkage pins.

STEP 9

For hydraulic breaker operation, see “Option pedal” in the “Controls/Instruments/Accessories” Section. TRIM THIS EDGE

311

TRIM THIS EDGE RIGHT PAGE

Alt= to hide template informationAlt+ to display template information

Template Name: OM_1_colTemplate Date: 1994_04_29