Complete Guide To Brother
Setup
MFC-J4335DW
When you have purchased a new printer for your home or workplace, you might be a little curious to print your documents or pictures smoothly. But, before operating your printer, you have to carry out the initial process. Setting up a new printer is quite an easy task, and you can finish it within a few minutes. Well, all you have to do is just spend your little valuable time operating your printer without any hassle. So, let’s get into the instructions to start setting up your Brother MFC-J4335DW printer!
Let’s Begin The Hardware Setup
Basic Printer Preparations
● Unpack the box and remove the printed documentation, power cord, and ink cartridges from the package.
● Gently lift the printer from the pack and place it on a flat surface.
● Make sure that the delivered contents (including the Brother printer) are not defective.
● You can now start discarding the packing materials around the printer.
● Then, remove all the protective tapes from outside and inside the printer
Fill The Paper Tray With Plain Sheets
● First, pull out the paper tray completely from the printer and move the paper width guides to the outward position.
● Fan a stack of plain white sheets and insert it into the paper tray.
● Now, adjust the paper width guides to the edges of the stack. But not too tightly
● Slowly insert the paper tray into the printer.
● Next, pull out the paper support and raise it.
Make Your Printer Ready To Operate
● Connect the power cord to the back of your printer and the other end to an electrical outlet.
● Turn on the printer.
Is everything okay there? Great! Way to go!
Proceed To Ink Cartridge Installation
● Open the ink cartridge cover of your printer.
● Now, uncover one of the ink cartridges from the package and remove the protective tape.
● Carefully insert the ink cartridge into the respective slot.
● Make sure that the ink cartridge is installed correctly in its place.
● Repeat these instructions to install the remaining ink cartridges into the printer
● Close the ink cartridge cover
● Now, go to the printer’s control panel and set the date & time by following the on-screen prompts.
● Then, go ahead with on-screen instructions to print the Print Quality Check Sheet and the Alignment sheet.
● Load the printer Alignment page with the scan side facing down on the scanner glass and perform the on-screen prompts on your printer to complete adjusting the alignment.
● If you want to change the language setting, go to Settings > Initial Setup > Local Language and press the OK button.
Great job! You have now gone through the hardware setup of your printer Let’s move on to the procedure for software setup.
The Printer Setup Executed Perfectly!
Hopefully, you could have now learned how to set up your Brother MFC-J4335DW printer by executing the above instructions. Also, you have learned about the driver downloading, installation, and connection method on this page. Well, if you have further queries about your printer, contact our technical experts using the call option.
