DIY - How to Replace an iPhone 7 Screen

DIY - How to Replace an iPhone 7 Screen The iPhone 7 Plus's screen is vulnerable, such as dropped, smashed, or otherwise chipped against surfaces, so much as you completely smash your screen, you're probably in need of a screen repair. When you crack your screen, maybe you will encounter some difficulties about detail, such as it also destroys your iPhone's water resistance. If your iPhone 7 Plus screen is broken, you want to replace the screen by yourself. This article will help you.

Repair Process: 1. Put off the iPhone 7 Plus.

2. Using a TS1 (0.8mm) screwdriver to remove the two screws, at the bottom of the phone locate.

3. Above the Home button, put a suction cup directly on

the display and gently try to remove from the rear casing.

4. If necessary, use a wedging device to carefully break the seal of the adhesive and pry the display from the rear casing.

5. Open the iPhone 7 display and remove the four screws to free the display plate. Then use tweezers to lift the display plate away.

6. Use the spudger tool to pull of the three LCD connecting cable strips.

7. Unscrew two more tri-point screws at the top, right-hand corner that hold down your proximity sensor.

8. Remove the plate over the proximity sensor reveal one more cable strip that, when disconnected, will free the front display from the back of the phone.

9. Remove the three Phillips-head screws from the bracket behind the ear speaker at the top of the display side.

10. Pulling away The bracket to reveal the iPhone ’ s camera.

11. Pull back the camera to remove the two screws holding in the ear speaker assembly, and lift out the ear

speaker.

12. Gently wiggle and pull up on the proximity sensor to remove it. Find the touch ID assembly, at the bottom of the display side.

13. Unscrew the four tri-point screws holding down the bracket, and remove bracket.

14. Gently wiggle to remove touch ID, then remove the LCD back-plate by unscrewing six, tri-point screws.

15. Using the spudger tool, lift up the LCD back-plate to reveal the cable strip connected to back-plate.

16. When you free the LCD back-plate of the cable, it will disconnect easily.

17. Discard your old, damaged LCD and replace with the new screen, folding down your cables and lining up the side mounts, to put the 6 screws back into place.

18. Continue to follow the steps in reverse to reassemble the phone.

More information about phone repair guide and tools, you can choose Vip Fix Shop Team.