DS200CDBAG1B - CONTACTOR DRIVER CARD worldofcontrols.com/ds200cdbag1b-contactor-driver-card
SPECIFICATIONS Part Number: DS200CDBAG1B Manufacturer: General Electric Series: Mark V Function: Contactor Driver Board DS200CDBAG1B is a Contactor Driver Board and is part of the GE Speedtronic Mark V gas turbine control panel. That serves as an interface for high-speed contactor drive control. The CDBA board provides power to open and contactor that is controlled by the DS200DCFB, DS200DCFB Power Supply Board(DCFB), DS200SDCI Dc Power Supply and Instrumentation Board (SDCI), or Feedback Acquisition and PowerSupply Board (DCVA).DS200CDBAG1B has three plug connectors and one terminal board with four sections to receive input signals and send output signals. The driver board is housed in a cabinet that is easily accessible to the servicer. All connectors are easy to open and enable the servicer to remove all cables from the board. One jumper is placed on the driver board, and it is reserved for testing purposes. When replacing the board, pot RV1 on the new(replacement) must be set to the same position as that on the board being replaced. Failure to adjust the pot might lead to contactor coil failure. There is only one group on the CDBA board, G1. However, the G1 board has two revision levels, G1A and G1B. All G1A revision boards do not have the coordinated operation feature and JP2 and LED1 are not included on the boards. G1BBA to present revision boards provide coordinated operation and include JP2 and LED1. WOC has the largest stock of Speedtronic Mark V Spares and we can repair your faulty spares with a warranty. WORLD OF CONTROLS can also supply UNUSED and REBUILT components backed up with a warranty. Our team of experts is available round the clock to support your urgent needs related to critical spares, contact us.
FREQUENTLY ASKED QUESTIONS What is GE Mark V DS200CDBAG1B? The DS200CDBAG1B is a Contactor Driver Board that opens and closes the Contractor. What Should the Contactor Voltages be When Using the Driver Board? The Coil voltages of 30 to 40 VDC are required for contactors used with the Driver Board. 1/2