HOWTOUSE VACUUMPUMP FORAIR CONDITIONER

BYWESTTECHNOLOGY

Using a vacuum pump for an air conditioner is a crucial step in the installation or repair process. It is used to remove any air or moisture that may have enteredthesystemduringinstallationormaintenance.
Properlyusingavacuumpumpforanairconditioneris essentialtoensurethatthesystemrunsefficientlyand effectively. By following these steps, you can ensure that all air and moisture have been removed from the system and that there are no leaks present. Here are the steps to properly use a vacuum pump for an air conditioner,
Before starting, ensure that the vacuum pump is properly assembled and that the oil level is correct. The vacuum pump should also be equipped with a suitable vacuum gauge and the necessary hoses and fittings.
ConnectTheVacuumPump: Connect the hose from the vacuum pump to the lowpressure service port on the air conditioner. The low-pressure port is typically marked with a blue cap and is located on the larger of the two refrigerant lines.
OpenTheValves: Open both the high and low-side valves on the manifold gauge set. Thiswillallowthevacuumpumpto drawairoutofthesystem.
Turnonthevacuumpump: Turnonthevacuumpumpand monitorthevacuumgauge.The
gaugeshouldreadbetween500
and800micronsofvacuum.Ifthe gaugereadshigherthan800 microns,theremaybealeakinthe system.
Runthevacuumpump: Allow the vacuum pump to run for at least 30 minutes to ensure that all air and moisture has beenremovedfromthesystem.If thevacuumgaugedoesnothold steady after 30 minutes, there maybealeakinthesystem.
Closethevalves:
After the vacuum pump has run for the appropriate amount of time, close the high and low-side valvesonthemanifoldgaugeset.
Turnoffthevacuumpump: Turn off the vacuum pump and disconnectthehosefromthelowpressureserviceport.
Checkthevacuumlevel:
Checkthevacuumgaugeagain
to ensure that it is holding steady at between 500 and 800 microns. If the vacuum level is not steady, there may be a leak in the system that needs to be repaired.