SkyLite - Installation Manual - Internal Installation

SKYLITE V2 Installation Manual

English

ATTENTION: In order to function properly, SkyLite V2 must be connected to a dimmable driver/ballast.

NOTE: Some dimmable drivers/ballasts must be programmed/set to dimmable mode. If this has not been done, SkyLite V2 will not be able to dim the connected armature.

TVILIGHT BV / Westerhaven 13, 9718 AW Groningen, the Netherlands +31 (0)50 800 3240 / info@tvilight.com / www.tvilight.com

v 1.0 30/06/2015

In box: SkyLite V2

External Antenna

Cable Assembly

120 mm

55 mm

You’ll need: Drill

10.5 mm

Screw Driver

Page 3 of 10

1. Connect Cable Assembly

2. Open Armature

Page 4 of 10

3. Access Electronic Gear

4. Drill hole in top of Armature

Page 5 of 10

5. Place Antenna through hole

6. Tighten Antenna using Antenna Nut

Page 6 of 10

7. Place SkyLite V2 Screw into place

8. Connect Antenna to SkyLite V2 Tighten SMA connector with a torque of 0.8 Nm (finger tight)

Page 7 of 10

9. Connect SkyLite to Driver

Page 8 of 10

Wiring Diagram

To Armature

TVILIGHT SKYLITE V2

Driver

DC- DC+ N

L

GND N L DC+ DC-

AC1 AC2 AC3

To Mains

Page 9 of 10

10. Return Electronic Gear to position and close Armature

Page 10 of 10