How To Install Polycarbonate Sheets Perfectly? - Tuflite Polymers

Polycarbonate sheets can be a great advantage if you finalize on installing them for your structure. The most popular benefits include strength, durability, insulation, and ease of installation. But, all of this is possible only if you install the polycarbonate sheets the right way. Especially, if you want to take advantage of the special UV protection that the polycarbonate sheets provide, you need to make sure you are installing them correctly. Yes, polycarbonate sheets come with a special UV protective coating on one side of the sheet. If the polycarbonate sheets are installed the right way, you can prevent the UV radiations of the sun from entering the structure; thus bringing in only the good amounts of sunlight. So, here is a guide that can help you install polycarbonate sheets just perfectly.

Step 1 – Be ready with safety gear First and foremost, you must have all your tools and safety gear in place. You will need a measuring tape, pencil, sharp toothed scissors or saw, purlin tape, screws, And, although cutting, drilling, and installing polycarbonate sheets is a safe process; yet it is always better to be safe. Thus, you must have safety goggles, gloves, and a safety harness in place. Appropriate footwear is also important for walking on the roof.

Step 2 – The right side up This is the most crucial step. As we told you above, polycarbonate sheets come with a special UV protective layer on only one side of the sheet. Thus, it is very important to install this side up so that you can take benefit of this property. If you use it the other way round, you won’t be able to take the benefit. So, keeping in mind this very crucial step, take the dimensions of your space, mark it appropriately on the polycarbonate sheet, and then, cut the sheet with the help of sharp toothed scissors or a saw. To prevent expansion noise, you can lay out purlin tape over the rafters before the installation process.

Step 3 – The correct fixings Remember that polycarbonate sheets naturally expand and contract with temperature. Thus, you will need the correct fixings to allow such expansion and contractions without issues.

When you drill holes into the polycarbonate sheet to fix them over the structure with screws, you must pre-cut the hole a little wider to allow for expansion. This will prevent your sheets from buckling. Also, you must use a large rubber on the screw to seal on the sheet and stop any water from penetrating the roof. Also, tighten all your fixings adequately to prevent rattling. But, also remember that over-tightening the fixings can cause distortion and excessive stress, thus causing failure of the sheets.

Step 4 – Finishing After installing the sheets, you will need to finish the structure with suitable products like a ridge cap and barge caps. These will fit well over the structure, preventing air and water from penetrating within.

With these easy steps and careful considerations, you can have a beautiful and strong structure built. And, to get the best quality polycarbonate sheets, you can always get in touch with Tuflite Polymers, the best solid, textured, corrugated, and multiwall polycarbonate suppliers in India.