Sct tt package setup

setting up your rega rp1 turntable

Step 1: remove from packaging - Carefully remove the turntable from the box and foam protection.

- The tonearm counterweight is packaged inside the foam block. Do not discard.

- Retain all packaging if you intend to transport the turntable in the future.

weight

tonearm

Step 2: install the counterweight - Insert the counterweight onto the back end of the tonearm.

- Twist as you push.

- Push until you reach to stop point. This calibrates your tonearm for the pre-installed Rega Carbon cartridge.

Step 3: remove platter - To remove the platter, lift straight up.

- Set the speed of your turntable to 33 or 45 RPM by moving the belt to the appropriate wheel. See diagram below.

stop point

setting up your rega rp1 turntable (cont.)

Step 4: remove the spacer - The cardboard spacer protects the motor during shipping.

- Remove tape and slide the spacer out.

- Replace platter and lay the felt mat onto the surface to protect records.

Step 5: install the dust cover - Slip the tabs of the dust cover into the slots on the back of the turntable.

- Gently lift the front edge of the dust cover to open.

Step 6: plug into phono preamp - Your turntable requires a phono preamp which is pre-installed inside the back of your cabinet.

- Plug the RCA phono leads from your turntable into the input jacks on the phono preamp.

- The output of the phono preamp is pre-wired to line 1 on the main preamp.

- Plug the turntable power cord into the power strip located inside the cabinet.

Customer Support: 845.358.9430 M-F 10-6 EST

phono preamp

input line 1

output

line 2

out

power