N STRIVE 14 GW BINDING

TO BE MOUNTED BY A SALOMON AUTHORIZED DEALER ONLY.

BINDINGS INTENDED TO BE USED ONLY WITH ALPINE BOOTS COMPLIANT WITH ISO 5355 STANDARD AND SKI BOOTS EQUIPPED WITH « GRIPWALK » LABELLED KIT OF WALKING SOLES

ISO 5355 WTR ISO 9523

ISO 23223

WARNING

THESE ALPINE BINDINGS ARE INTENDED TO BE USED ONLY WITH THE FOLLOWING SKI BOOTS: > Alpine ski boots compliant with ISO 5355 standard. > Ski boots equipped with « GripWalk » labelled kit of walking soles. Any use with other ski boots could cause the ski-binding-boot system to be faulty and affect release characteristics, which would increase the risk of serious injury while skiing. Therefore, skiers are warned not to use this product with any ski boots other than those meeting the standards indicated above. Skiers are advised to consult the dealer where this product was purchased, or an equipment specialist at any SALOMON authorized ski dealer of this product, for further information regarding which ski boots meet the standards listed above.

ALPINE SKI BOOTS (ISO 5355) TYPE A (Adult) TYPE C (Children)

GRIPWALK BOOTS (ISO 23223) TYPE A (Adult) TYPE C (Children)

MOUNTING & ADJUSTING

1. For mounting N STRIVE 14 GW on skis, holes must be drilled with Salomon mounting jig (ref. L3910910001) to ensure a proper alignment of the binding.

Mount the toe piece base and the rear plate on ski by tightening the screws with a 4 N.m torque.

Following a renewal of jigs stickers, here is the new template.

> > > N STRIVE 14 GW BINDING

2. Insert the heel and break piece from the front on the rear plate and adjust it properly according to the boot sole length.

3. Insert the toe piece on its base and tighten the screws with a 4 N.m torque.

4. Step in the boot.

5. Check and adjust the forward pressure.

6. Select and adjust the setting release values for toe and heel pieces.