Bolo Ties And The Way To Correctly Make Your Own Bolo ties are a wonderful fashion choice that can replace a traditional tie, giving you a more Western look. They are trendy in the American West, especially in Arizona, New Mexico, or Texas. Pre made bolo ties are offered but it may be more fun to make your own. On the internet there is a tremendous selection of bolo tie parts available to create one-of-a-kind tie accessory. When making a bolo tie, you first need to assemble all the required parts. Bolo ties are relatively easy, so a small number of parts are needed. The tie itself is made up of a decorative slide that rides up and down using a braided leather cord. A metal bolo tip is employed to help secure the end of the cord. You must purchase a bolo slide, metal tips, leather cording and a decorative stone or pendant when making your own special bolo tie. Various other tools you should have are pliers, a metal file, glue, and scissors. To start with, decide the length of cording you will need. You can buy leather cord pre-braided, or you can also braid your own. You will need a section about 40 inches long for the tie. Slip the cord around your neck, and find the exact length you need. If the cord is way too long, clip it so that the ends are well above your belt line. Next, check that the leather cord fits through the holes in the bolo slide. The metal could possibly be bent slightly if the cord is not able to fit in the slide. Take your metal file, and file out any bumps in the bolo slide where the cord passes through it. Not only should smoothing out the metal be better off for the cording, it will be able to last a lot longer. With the stone or pendant you picked out, make sure there is a flat surface to attach the embellished piece to the slide. While using jewelry glue or super glue, attach the stone to the slide and allow it to completely dry. After the glue is dry, it is time to put the whole thing together. Slide each end of the cording through the bolo slide, and very carefully tighten the bends of the slide by using pliers so that there is some friction holding it in place. You need to be able to very easily adjust the cording but tight enough that it stays in position. The final step is to attach the bolo tips using a little bit of glue inside and inserting the ends of the cord. Also you can use pliers to bend the tips just a little to hold them onto the cord. And with that very last step you are basically finished. By placing the tie over your head, test out the bolo and slide it in place. A lower placed slide will look more casual in contrast to a higher resting slide will look more professional. Once you have made one bolo tie, you may find yourself wanting to make even more for friends and family, or just for yourself! In a huge variety of styles, the possibilities are endless for bolo ties in relation to colors and designs. Different colors of leather can be braided together with each other, or beads can be added to the bolo tips for some extra flair. Making your own bolo ties can be accomplished in a multitude of ways where you can highlight your creative side, crafting amazing pieces. Before long, you too can become a bolo tie expert. Buy bolo tie parts from Rocky Mountain Western as soon as you are organizing a wedding or Rocky Mountain Western, LLC
Page 1