DVC6200 Instruction Manual June 2011

Page 28

Instruction Manual

DVC6200 Digital Valve Controller June 2011

D103409X012

Mounting Fisher 67CFR Filter Regulator A 67CFR filter regulator, when used with a DVC6200 digital valve controller, can be mounted one of three ways.

Integral‐Mounted Regulator Refer to figure 2‐19. Lubricate an O‐ring and insert it in the recess around the SUPPLY connection on the digital valve controller. Attach the 67CFR filter regulator to the side of the digital valve controller. Thread a 1/4‐inch socket‐head pipe plug into the unused outlet on the filter regulator. This is the standard method of mounting the filter regulator. Figure 2‐19. Mounting the Fisher 67CFR Regulator on a FIELDVUE DVC6200 Digital Valve Controller 67CFR

CAP SCREWS O‐RING NOTE: 1 APPLY LUBRICANT

1

SUPPLY CONNECTION

W9702

Yoke‐Mounted Regulator Mount the filter regulator with two cap screws to the pre‐drilled and tapped holes in the actuator yoke. Thread a 1/4‐inch socket‐head pipe plug into the unused outlet on the filter regulator. No O‐ring is required.

Casing‐Mounted Regulator Use the separate 67CFR filter regulator casing mounting bracket provided with the filter regulator. Attach the mounting bracket to the 67CFR and then attach this assembly to the actuator casing. Thread a 1/4‐inch socket‐head pipe plug into the unused outlet on the filter regulator. No O‐ring is required.

Pneumatic Connections Pressure Pressure connections are shown in figure 2‐20. All pressure connections on the digital valve controller are 1/4 NPT internal connections. Use at least 10 mm (3/8‐inch) tubing for all pressure connections. If remote venting is required a minimum of 12.7 mm (1/2‐inch) tubing should be used. Refer to the vent subsection for remote venting information.

28


Turn static files into dynamic content formats.

Create a flipbook
Issuu converts static files into: digital portfolios, online yearbooks, online catalogs, digital photo albums and more. Sign up and create your flipbook.