INSTALLATION INSTRUCTIONS Yamaha Raptor 700 Rear Grab Bar To avoid injury to yourself or damage to the ATV, read these instructions completely before installation. 1. Parts List: Item 1 2 3
Part Name Description Rear Grab Bar Washer M6 Washer Nylock Nut M6 Nylock Nut
Qty 1 2 2
2. Preparation: a)
Remove the OE rear grab bar and retain the mounting hardware and all Tail Light hardware. Rubber grommets must be removed and retained.
3. Installation: a) Install your new Rear Grab Bar on bike. With a box knife, trim the left side fender at the dotted line to allow fitment of the Grab Bar as shown. b) Re-install the four OE 8mm bolts (2 per side) into mounting holes of Rear Grab Bar. c) Re-torque the four OE 8mm bolts to 25 N-m (18.5 ft-lbs) d) Re-install the Brake/Tail Light to the Rear Grab Bar using all OE grommets and hardware. BEFORE e)
Install Item #2 washers and Item #3 nuts at fender support mounts, reusing OE bolts.
4. Maintenance: 5. Care and Cleaning: 6. Customer service:
Periodically check all fasteners for tightness and retorque as required. Clean using a soft cloth and a non-abrasive metal polisher. For further information call Pro Armor at 951-270-0559 Y063060