Fixed Side Plate Installation (Fig. 28 and Fig. 29) 1. Remove pop rivets and rear height–of–cut plates from both sides of the cutting unit (Fig. 28).
2
6
4
2. Remove lock nuts, capscrews, washers, and both links from the cutting unit (Fig. 28). 3. Align fixed side plate with holes on the cutting unit (Fig. 29).
1
4. Attach new capscrews, washers, and flanged lock nuts to the fixed side plate and the cutting unit (Fig. 29). 5. Tighten lock nuts and capscrews
3
6. Fasten new height–of–cut plate to the cutting unit with new pop rivets (Fig. 29). 7. Repeat steps 1. through 6. for the other side of the cutting unit.
5 Figure 28 1. Pop rivet 2. Height–of–cut plate 3. Lock nut
4. Capscrew 5. Washer 6. Link
5
1
6
3 4 2 Figure 29 4. Flanged lock nut 5. Height–of–cut plate 6. Pop rivet
Cutting Units
1. Fixed side plate 2. Capscrews 3. Washers
Reelmaster 2300–D/2600–D
Page 7 – 25
Cutting Units