What are the Common Causes of Malfunctioned Torque Converter in Mercedes

What are the Common Causes of Malfunctioned Torque Converter in Mercedes

You can diagnose the malfunctioned torque converter of your Mercedes by performing the simple test. So, first, you have to start the car and let it idle for a few minutes.

After that put your step on the gas lightly for a few times and let it come back to idle by pressing down the brakes and then shift into drive.

During this period, if you listen to any types of strange sounds from the car such as the clicking or revving, then take your car for inspection.

After that, you have to shift all the gears including the reverse and try to notice any of the aforementioned signs again.

The below points define the common causes of malfunctioned or damaged torque converter in your Mercedes.

Failed needle bearings

The needle bearing of the Mercedes is generally used for separating the stator,turbine, impeller and converter housing.

If the needle bearing of the car is damaged, then it will cause the transmission to make strange noises while driving.

The metal to metal contact between the parts of the converter creates metal chips which can pick up the transmission and cycles around the transmission.

Damaged torque converter clutch

Like the manual transmission car, the Mercedes has clutches throughout the transmission as well as part of the torque converter assembly.

When the torque converter of your Mercedes is jammed from locking up or burn from high heat temperature, it can be damaged.

In general, it can also break down under severe conditions. If the clutches of the torque converter is sucked, the car will stay in gear when you try to stop it.

Solenoid torque converter clutch Thus, the torque converter clutch solenoid is an electronic component which can control the amount of fluid which passed on the torque converter clutch.

If the torque converter clutch solenoid of your Mercedes is malfunctioned, then too much to too little fluid will be released and cause abnormal fluid pressure.

When the solenoid torque converter clutch of your Mercedes is damaged, then it will cause engine stalling and poor fuel economy.

Broken torque converter seals

The broken torque converter seal of your Mercedes will generally allow the fluid to leak out of the converter.

Due to the broken converter seal, it will cause a number of problems such as the slippage, shifting and overheating problems.

When you notice the broken torque converter seal in your Mercedes, try to inspect and replace it on time.

If you neglect the issues of the malfunctioned torque converter of your Mercedes, it will cost you more than the replacement cost.

When you notice the problem and issues in the torque converter, then replace them on time for preventing the other damages.

Visit Us https://www.munichwest.com/