www.merseyrod.co.uk
Tips To Repair Drains A clogged drain line is an ideal trouble spot: It can be hard to diagnose, easy to damage if you handle it yourself. So, it is perfect to hire a drain repair Wirral company. But there are several simple things you can do to fix your leaky drains without calling a pro — or resorting to expensive store-bought plumbing snake products.
Unclog stuff by hand If your bathroom sink or tub is draining slowly, grab some rubber gloves and pull out the stopper in the bottom of the sink or tub drain. Be ready with the plunger to force out whatever has dropped into the gutter. You must take help from the Wirral drainage company.
1
www.merseyrod.co.uk Fix a slow drain If the clog is farther down the line, you’ll have to remove more of it by hand or stick your hand further down where it’s wetter and smellier. Here’s how to do it safely: Most important, keep your body parts out of harm’s way Stick one thigh up the drain to keep them clear of the whirling water as you plunge. Whack away at the blockage until it’s dislodged, then flush with boiling water. Wipe off any slimy residue inside the drain with a rag. Add some baking soda and vinegar to keep the drain clear: Pour half a cup each of baking soda and vinegar into the drain and follow it with two quarts of boiling water. If that fails, try building your hand-powered auger These devices usually cost $10 to $20, but you can easily create one yourself for less than $3 if you have an old toilet plunger on hand (or know where to get one). Just saw off the handle (the part you press against the floor when using the plunger), leaving about 4 inches of the shaft sticking up from the hard rubber suction cup attached to one end. Then find a screw end with a long post that’s slightly smaller in circumference than the plunger cup, and glue it to the top of the plunger.
2
www.merseyrod.co.uk Fix a slow-draining shower by removing clogs from inside the pipe Often you can remove a hair clog with a bent wire hanger. Detach one end of a clean metal hanger, wrap that end tightly with heavy-duty aluminium foil about two inches wide, then bend the other end into an L shape. Hold your hand or washcloth over it as you plunge, so no sewer gases escape into your bathroom. To fix the showerhead itself, unscrew it (usually requires hand pressure), pull off any grit clinging to its side with pliers, then put everything back together again after washing it in hot soapy water.
3
www.merseyrod.co.uk Conclusion If a plunger or a homemade auger doesn’t do the trick, have an expert snake it out; If plunging and snaking don’t work, you may need to call a plumber. Even if only one toilet is affected, it’s good to know about all your drains: The blockage could be in any connected pipe, including ones that go outside under the house. A clog can form anywhere along this line, even where sewer lines connect at Y junctions. Here’s how to protect yourself and get repairs done correctly:
4