Ideas to Cover Popcorn Ceiling by House Painter Toronto

Cover Popcorn ceiling with drywall cover Summary: 1/2 inch or 1/4 inch drywall installed on the existing popcorntextured ceiling drywall Explanation: Since you already have drywall on the ceiling, why not add another layer below it?

As the home is reshaped, it is often easier to cover up the problem area than to completely remove and replace the area. The floor is usually covered by a second layer.

Covering an existing ceiling with drywall means you don't have to worry about asbestos or lead paint, which is usually included in texture and paint.

Cleanliness is also an advantage. Since you will not pull out the drywall, you do not need to deal with a large amount of attic insulation, debris, and pest dung when the drywall is lowered, which will rain inside the house. You can also contact the house painter in Toronto to get better quality of drywall installation.

Cover the ceiling with prepared ceiling planks Introduction: Covered with fiberboard planks specially made for this purpose. Planks are laid on the edge of the strip.

Description: Woodhaven ceiling as a substitute for removing popcorn ceilings, etc.

The thickness of these MDF ceilings is a tongue, and each is 5 inches by 84 inches thick.

For best results, you may want to use the Easy Up grid system. Just like the traditional ceiling grid, it can keep all panels stable and orderly.

But unlike the ceiling grid, the grid is not visible. The circuit board is connected to the outside of the grid through a snap-in clip.

If the drywall is flat, the Woodhaven ceiling can be installed directly on the drywall.

In addition, attach a grid of waterside strips (1 x 2 boards, available in most home improvement centers). Although this allows you to fill the grid to full level, you will also lose some of the ceiling height from the added water seal layer.

Ceiling with tongue and ceiling pine ceiling Introduction: Individual natural wood pine boards are purchased at the lumber yard or home improvement store.

Explanation: As an alternative to expensive ceiling systems, why not install something cheaper on your grid? This DIY method uses low-cost wood found by local retailers. Most home improvement stores have tongue and groove cork (such as pine or fir) that you can nail directly to the water edge strip.

Remove popcorn texture Lay the floor with plastic boards. Climb up the ladder. Scratch off the popcorn texture. Pile up the plastic and throw it away. Paint the ceiling.

In a perfect world, it should be so easy, but often it is not. Removing the popcorn ceiling texture brings its own set of problems.

First, assume that the texture contains asbestos. The removal of these materials even requires special care.

Hiring an asbestos removal company is expensive. On the other hand, removing popcorn is a lot like scraping paint: assuming that easy slices indicate that the rest of the surface area is deceptive.

One area is easy to fall off, while other areas are so difficult that you are shaving the cardboard to remove it.

On the other hand, removing popcorn can provide you with the maximum ceiling height. For highly challenging areas, such as basements, with counts per inch, you may want to remove the texture for the reason.

Contact today the Popcorn Ceiling expert in Toronto for any kind of ceiling removal or repair services in Toronto.

Hire House Painter to Cover Popcorn Ceiling

Mas Construction Painting Contractor

Amos Crescent, Toronto, ON City - NORTH YORK Zip - M3H 3X8 +1 647-835-0590 Info@Mascons.Ca

www.mascons.ca