QPR Asphalt Patch ǀ A Quick Cure for Your Asphalt Surface

How To Repair Potholes Using QPR Asphalt Patch?

Distress in the road surface is common because of heavy loads of vehicles and different weather condition. However, we don’t always renew the road surface for small cracks. If you are renewing the surface then this requires more budget and you may have to stop the traffic for a few hours. So, QPR is there to serve your purpose.

Irrespective of weather condition this cold patching method works best for your asphalt surface. If you don’t have a big budget and cracks are small enough for surface renewal, QPR asphalt patch is the better pothole repair solution for you.

Main Infrastructure is one of the best pavement repair company which provides a solution to all your patching needs. We provide services for asphalt patching, crack sealing, pothole spray patching, and asphalt paving.

Quality Pavement repair (QPR) is used to repair the utility cuts, cracks, and holes in the driveways. It is the permanent solution for your cracks, it has a great bearing capacity and is rutting resistant. QPR asphalt patch is very much suitable for your distressed road surface.

Uniqueness in QPR are · It can be applied in wet roads, during frost and when the ground is frozen

· Extremely good adhesive, can be applied to steel and concrete as well.

QPR Pothole Repair Features · Easy to use and works instantly

· It stays permanently where it has been put · You can use this in all types of cracks irrespective of your job size · Guaranteed performance · DOT approved · Usable from -5°F to 105°F QPR gives a permanent solution for your driveways cracks whereas other cold-mix asphalt doesn’t last long.

There is no mixing required before applying on the surface. All you have to do is apply, compact, and then open for the traffic immediately. This material is suitable to use in both hot and cold weather conditions.

How We Use QPR Asphalt Patch? 4 STEPS Here we are sharing steps for Best Asphalt Patch instructions that will help you to repair cracks and potholes.

Step 1: Clean the Surface Clean the damaged area properly for any loose material where you have to apply QPR. For applying QPR we don’t need to sweep for the water from the patch because the material can be applied even in water.

Step 2: Pour the Material You don’t have to do so much hard work to pour the material. Since the material can be compacted even in the water we can simply take the material out from the bag and apply inside the hole. You don’t have to worry about the water or moisture. Add the material deep inside the hole.

Step 3: Spread the Patch Material Once the material has been applied to the required surface, spreading is needed to be done.

When a 2-inch base is there use a spreading tool (tamp) to spread the material evenly into the cracked area. Reapply the material in 2-inch increments, until the cracks are filled.

Step 4: Compact the Surface Just after the material has been spread, you need to compact the surface to give it strength and smooth driving experience. When cracks are filled, use a wheel roll to provide compaction to the surface. Again do the final wheel rolling for the final compaction to give it strength.

Once the surface is compacted open it immediately for the traffic.

Sick of repairing the same cracks again and again?

Don’t Worry!!

We are here to help you out!!

We at Main Infrastructure provide the best asphalt pavement services with the experienced certified professional. Along with this, we use the best pothole patching machine & top quality materials to enhance surface performance and lifespan.

Reach out to us at Main Infrastructure for your pothole repairing services need or call us @ +1 (416) 514 0809.