Programming the Digital Display 1. Turn on display 2. The display normally will be set for German language. You will need to change it to English. 3. Press and hold the P button for about 3 seconds or bars at upper right hand corner are gone then you will be the program mode. 4. Then keep pressing the P button till you have reached the last mode SPr. The Spr mode is defaulted to d. By pushing the up arrow key, change the mode from d (German) to E (English). Then press the * button to save. Keep on pressing the P button till the mode function ends. This mode will change to LAn (Language) after the setting is done. 5. Now that the digital display is in English language you will need to program the other modes. Press and hold the P button for about 3 seconds or bars at upper right hand corner are gone then you will be the program mode, as mentioned on #3 above. 6. Display rES will be blinking. Hit the up arrow key till desired metric or SAE setting. Standard setting will be at SAE up to 1/32�. Press the * button to save. (by pressing the * button at any time during the programming protocol you will be saving any changes). Then press the P button to move to the next mode. (By pressing the P button while in program mode will change to next mode till it ends) 7. The next mode is the ref (Reference) mode and this mode could be set at any number that is desired. Use the left arrow to move the desired digit and then the up arrow key to change the digit, standard setting will be at 010.000 but it could be set at any reference the operator wants to use. Press the * button to save then press P for the next mode. NOTE: the reference mode will be your calibration setting. Example, if you turn off the digital display and the fence was moved your digital display will not read the correct distance from the blade to the fence. By pressing the star button (*) (not in the program mode) it will change back to the reference setting as mentioned above #7, first make sure your fence is positioned at the reference number programmed before pressing the star button (*). 8. The next mode is the oFS (off set) mode and this mode will be set to the default at 000.000. Use the left arrow to move the desired digit and then the up arrow key to change the digit; standard setting will be at 000.000. Press the * button to save then press P for the next mode.
1