Page 1

Motor mount (make 1)

F-2

F-1

Designed by Steve Shumate

Servo tray (make 1)

Fwd Fuselage Sides (make 2)

Copyright Š 2004

All Rights Reserved

3/8" balsa triangle

1/2" wide foam strip

3/4" square 1/64" ply doublers on inboard side (drill 3/16" hole for pivot bearing tubes)

1/2" wide foam strip

Aft Fuselage Bottom (make 1)

Template for rudder pushrod endElevon and rudder control horns (make 1 from 1/32" music wire) (make 3 from 1/32" plywood)

4

Fuselage top spine (make 2 and laminate)

5/8" foam tria ngle

Turtledeck Sides (make 2)

2

2

4

Bulkhead F-2 (make 1)

Fwd fuselage top outside (make 1)

0

Bulkhead F-1 (make 1)

Wing (make 1)

Turtledeck Top (make 1)

Canopy (make 12 with 6 mm Depron (14 if BlueCore) and Note: Inside of canopy can be laminate together) hollowed out if airplane CG is not already too far aft

Canard (make 2) Nosecone (make 12 with 6 mm Depron (14 if BlueCore) and laminate together)

Nosecone top view template (trace outline on top of nosecone to assist in carving it to shape)

Fwd Fuselage Bottom (make 1)

Scale in inches

Fwd fuselage top inside (make 1)

Aft wing fairing (make 2)

Vertical Tail (make 1)

Inlet spacer (make 2 from 3 mm Depron)

Missle rails (make 2 from 1/4" x 5/16" balsa) Vertical tail radar fairing (make 2 from 3mm Depron)

Aft Fuselage Top (make 1) Inboard inlet sides (make 2 from 3mm Depron) Cut slot for vertical tail

Gripen park jet (parts templates nontiled scaled 127)  
Read more
Read more
Similar to
Popular now
Just for you